Armoured Aprons

Armoured apron shown in a typical lathe saddle application
Armoured apron shown in a typical lathe saddle application

The demand from machine tool and other industries for an economically priced, tough, lightweight armoured apron has been met by Beakbane with its ‘Mark 4’ design.

The unique design of the cross-section enables ‘linking’ to be achieved with a ‘hinge’ material allowing the apron flexible movement and a long wear life. The materials have good resistance to most of the commonly used lubricants and coolants. If in doubt, consult our technical department who will be pleased to help you.

Adapting the Beakbane Aprons to machines is easy:

  • They can be attached at either one or both ends
  • End fixings can be predrilled if required
  • Aprons are available up to a maximum width of 950mm
  • Available in most lengths to suit requirements

Click here to download our literature and enquiry forms, or here to complete an enquiry online.

Illustration

Technical Data

The following technical data will help you specify Beakbane Armoured Aprons for your machine:
Material: 19mm wide x 3mm thick aluminium slats (diagram A)
End Fixings: Type A – simply use an extra slat (diagram B) Type B – 90° extruded aluminium angle (diagram C)
Fixing Holes: Fixing screw holes up to a maximum 7mm diameter Number and centre dimensions to suit
Additional Fixing Requirements: When aprons are draped over the ends of slideways it is recommended that a minimum 25mm radius is provided for ease of operation (diagram D)
Tolerances: Overall length: +20mm / -0 mm Squareness: 1.5mm per 300mm length
Ambient Temperature: Maximum +60°>C – minimum -30°C
Tensile Strength: 2.5kgf/cm